Custom stainless steel jewelry manufacturer
1. Prong Setting
Common type: four-claw or six-claw insert
Requirements: the size of the claws is consistent, the spacing is uniform, the diamond table level is not inclined;
2. Channel Setting
Inlay way: use the metal slot to jam the gem on both sides of the waist;
Requirements: The use of this method to set more than one diamond should be the same caliber, size;
3. Bezel Setting
Inlay way: Wrap the part below the waist of the diamond with the edge of the metal sheet and seal it in the metal bracket.
Requirements: there is no gap between the gem set and the edge of the bag. The edge of the bag should be even and smooth. The groove edge should be smooth and smooth.
4. Tension Setting
Inlay way: call card to insert again, tension is set wait, use the tension of metal to extrude inward to fix diamond waist.
Requirements: large high quality diamonds, red and blue gems such as high hardness is not easy to crack the gem.
5. Common Setting
Inlay way: Use the message of the metal column will be each diamond separate fixed, also known as the common tooth, more often seen in diamond group inlay.
Requirements: Skilled tessellators, diamond particle size consisten
6. Pave Setting
Inlay way: On the metal material used to set gems, the edge of the setting, spade out a number of small nails, used to fix the diamond.
Requirement: At least 7 or more small gems are required to use this technique.
delleb jewerly is a high quality stainless steel jewelry manufacturers, focus on custom stainless steel jewelry rings, bracelets, earrings, necklaces, pendent & charms and stainless steel logo plate tags.